Printed on a 1.4 oz synthetic fabric with water based inks. This fabric is applied like a standard surfboard inlay, either in the nose of the board, bottom of the board, or on the whole deck. When glassing the board it is highly recommended that you get a gloss coat to bring out the full richness of color. This material goes semi-clear but has a milky ness look if applied over color work or dark line work, so apply on white decks and work around the potential visible seam (a pin line to transition from printed area to unprinted is the usual way). See detailed inlay instructions if your glasser is unfamiliar with the technique of applying an inlay.

Notes – this material is not structural and should not be left in high heat or direct sunlight for prolonged time period (basically just treat it like a normal board don’t be dumb and leave it in your car uncovered all day). This surfboard inlay can be used with both epoxy and polyester resin systems.